View Single Post
  #2  
Old 03-29-2013, 08:10 PM
Jeff in Pa's Avatar
Jeff in Pa Jeff in Pa is offline
Grand Member
 
Join Date: Feb 2012
Location: Zionsville, PA
Posts: 3,171
Default

90° Gear Box Shafts for tillers and snow throwers. Made from 3/4" diameter 4140 P alloy steel ( turned ,ground and polished ) with on size keyways and snap ring grooves cut.



$48 each or $92 for the pair plus shipping

If you have a "BB" angle drive gear box, I can make those shafts if you send me the shaft to copy ( it will be returned if wanted )

Just found out there are two different lengths of the short shaft in the 90* gear box. One ( as pictured above ) at 4-21/64" long and the other at 4-1/8" long.
Just let me know which one you want.


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Two more different lengths. Top on is 5-15/16" long and the bottom is 4-9/64" long


~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Transfer shaft for the QA snow throwers. $32 plus shipping or $30 with either ( or both ) of the above 90* gear box shafts


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
PTO pulley puller

The pulley puller uses the 5/16" threaded holes in the pulley to pull it off much easier.
Each unit is supplied with handle and threaded rod with centering point to locate on the crankshaft. Use a 9/16" wrench or socket.



It's used as shown here ( version shown in pictures does not have the weld cutouts, all pullers have that now)


$22 each plus shipping

~~~~~~~~~~~~~

Ross steering box adjustment screw (Cam Follower)



$8 plus shipping