View Single Post
  #5  
Old 02-25-2016, 09:34 AM
Nailhead Nailhead is offline
Member
 
Join Date: Sep 2015
Location: Colorado
Posts: 61
Default

Quote:
Originally Posted by Jeff in Pa View Post
As a machinist who regularly works with castings, trying to bend it is a very bad idea. If shimming gets it level, do that.
I was afraid of that.

Maybe I can drill a bolt hole on either side of the casting: one to snug the higher side down to the deck, and another opposite to hold some washers to act as shims. I'll need to adjust the length of the eyes on the front of the casting, too.

Thanks very much!
__________________
1965 122 with no bells or whistles, other than a spiffy restored 42" CI deck.
Reply With Quote