Only Cub Cadets - What would you carry

Page 2 of 2

Show 40 post(s) from this thread on one page

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)

- CCC/MTD Cub Cadet built Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=10)

- - What would you carry (https://www.onlycubcadets.net/forum/showthread.php?t=30871)

cubby102

03-28-2014 02:00 PM

I always have a crescent wrench some pliers mall pipe wrench (works well as a hammer in a pinch l) and a short chain. A couple heavy screwdrivers as well

ACecil

03-28-2014 02:08 PM

Quote:

Originally Posted by CADplans (Post 251125)

Gotta run what I brung! :bigthink:

:biggrin2:

My normal "tool box" is that yellow trailer hooked to the hitch! :biggrin2:

I hear ya, CAD! I'm the same way. :beerchug:

nikster

03-29-2014 08:42 AM

Duct tape.:biggrin2:

NIK,

PaulS

03-29-2014 08:54 AM

I have a similar tool box on one of my 102s. In addition to what has already been mentioned I always stored the little clevis that I used to hook up a chain as I could never remember where I put that thing. I also usually had some bundle ties. I have a wood splitter that has a ball hitch and stored the ball there too as I could never find it when I wanted to use it too.

cubfan

03-29-2014 09:36 AM

Why did I have to see this, just cost me $60.00.Gotta have one!!!!!!!!!!!!

PaulS

03-29-2014 09:47 AM

I built my own out of scrap wood. Drilled a hole or two and was good to go. Has lasted me for only aboiut 15 years.

drcjv

03-29-2014 11:14 AM

Quote:

Originally Posted by cubfan (Post 251237)

Why did I have to see this, just cost me $60.00.Gotta have one!!!!!!!!!!!!

More like $75 with shipping

Nubiru

03-29-2014 06:56 PM

1 Attachment(s)

Hey CAD you might want to invest in a Brush Bar :biggrin2::biggrin2::biggrin2: Paul

CTRUEX

03-29-2014 08:44 PM

Quote:

Originally Posted by drcjv (Post 251088)

My 1772 has a tool box on the back. Whith the limited space what would you carry. I am thinking 3/4 wrench for 3pnt, 15/16 wrench for 3pnt plow. Extra hair pins and hitch pins. I would like to carry a hammer but any one that would fit is not really big enough to be of any help. Any ideas on what might work as hammer and also fit.

I don't have a picture, but I seen, and then made, a 15" crescent wrench with a chunk of metal welded onto it, to double as a hammer. Not sure if it would fit, might have to use a 12". I have an old school 1/2"-9/16" reversible Craftsman ratchet wrench in mine, along with hitch pins and hair pins.

All times are GMT -4. The time now is 03:05 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page