Only Cub Cadets - Wheel weight bolts

Page 2 of 2

Show 40 post(s) from this thread on one page

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)

- General Talk (https://www.onlycubcadets.net/forum/forumdisplay.php?f=24)

- - Wheel weight bolts (https://www.onlycubcadets.net/forum/showthread.php?t=42268)

drglinski

01-06-2016 07:42 PM

I've got regular grade 5 bolts on mine. Sorta difficult to do with two wrenches, but I can get one back there and tighten em up.

Cub Cadet 123

01-06-2016 08:20 PM

Just an FYI, some people put weights on the backside of the rim, some are on the front and some are on both. Some run multiple sets of weights on, as well. Therefore, bolt length may vary. You said it was going on a 1050, so I do not know if they will fit on the backside with the breaks.....I have never done that on those before.

Cub Cadet 123

Jeff in Pa

01-06-2016 08:31 PM

Quote:

Originally Posted by Terry C (Post 357959)

1/2. :biggrin2::biggrin2:

Quote:

Originally Posted by darkminion_17 (Post 357961)

I see the IH ones are 7/16

Quote:

Originally Posted by Terry C (Post 357962)

I would go with what Lew said cause my bolts came with the weights and had nuts on them already. I used a 3/4 socket is what I based my answer on

I used 1/2" carriage bolts for my Gilson wheel weights.

"Heavy" 7/16-14 nuts and regular 1/2-13 nuts are both 3/4" hex

olds45512

01-06-2016 08:36 PM

Quote:

Originally Posted by Cub Cadet 123 (Post 357983)

i will be putting them on the outside only, i figured i have a couple sets sitting here i might as well use them.

All times are GMT -4. The time now is 04:41 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page