Yesterday

Mowed grass

added oil (got a 80-20 engine. burns 80% gasoline 20% oil)

Added air in front tires.

It was a good day.

Not technically a cub but I finally remembered to bring home an impact so I could get the blade off my IH push mower so I could finally get the engine apart, the bottom crank bushing is worn out and the crank moves around.

Good work Tim!

Pulled the blades off the zero turn and turned them around. The boy sharpened the blades last week and got them on upside down. I am sure it looked right from underneath!!

I did get on the Original and drive around the shop. Just because!




Randy

I pulled the fenders off the 1211 so I can access the leaking auto valve and to make room to install the dual hydrualics.

Very nice Tim, looking good!:beerchug:

Pulled the broken engine mount bolt out of the 1200.

Put wing nut on my 149 air filter, the PO had a nut on there.

Ordered a new spark plug, wire, air filter and fuel line for the 149. Also found a muffler mount / heat shield online and ordered it.

Still looking for a pressure line.

I took the blower off the 125http://i196.photobucket.com/albums/a...7/IMG_0950.jpg
Then i changed the oil in ithttp://i196.photobucket.com/albums/a...0297/125-5.jpg
The 38" deck is on and we mowed.....http://i196.photobucket.com/albums/a...0297/125-1.jpg

Good looking 125!

I saw the snow blower mounted ..hopefully wont need that for a while :beerchug:
..but since you`re in Indiana , anything is possible ..