You have been busy, are you hooking up the safety switch for the clutch pedal?

If I can find a flapper. This one is broke.

I installed new engine mount bushings and steering box gasket today. My clutch driver showed up and I got the driveshaft cut and drilled. Borrowed the 2072s seat and went for a test drive. :beerchug:

https://youtu.be/iq3fZEgBJOQ

Yesterday I took the steering knuckles off and beat the bushings out of the axle as they would not take grease. Cleaned everything up and now it steers great. I still need to replace all the rod ends. Might go with the heim joints.

Today I put the front tins from the super on since I need to do some paint on the ones I got with the 1050. Hell, these need paint too, at least they are white. Then I put it to work after mowing the lawns with the 1864. It was a great birthday with perfect weather! :beerchug:


https://i.postimg.cc/L5L1mfXS/IMG-20...-192216965.jpg

Happy birthday Mr. S. I don’t see you on the calendar? Our birthdays are close, 1050 took shape pretty quick. Wish now I didn’t sell my cast rear a little while ago with internal brakes. Cool project I’ve been following it closely.

Great job, Travis!