Only Cub Cadets
Page 6 of 12 12345 6 789101112
Show 40 post(s) from this thread on one page

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)
-   CCC/MTD Cub Cadet built Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=10)
-   -   Newbie and a 782D (https://www.onlycubcadets.net/forum/showthread.php?t=44890)

CubDieselFan 08-27-2016 05:26 PM
Yep you had a good day. Keep the pictures coming.

ACecil 08-27-2016 06:09 PM
Quote:
Originally Posted by DieselDoctor (Post 389335)
I had a good day in the shop today and made more progress on the 782D. The front and rear axles have been installed. The rear got all new seals and gaskets. The bearings were spotless even though the HyGard oil was milky when drained. Slowly hanging parts back on and getting more room in the shop as a result. It sure seems nice to be able to roll it around on brand new tires. As soon as I sort out the wiring harness and get the back side of the dash done, I'll set the engine back in. I hope to see smoke before the snow flies!
Very nice work! Thanks for the pics and update.

aagitch 08-27-2016 06:33 PM
Looking good!

Dirty Steve 08-27-2016 08:20 PM
Quote:
Originally Posted by aagitch (Post 389353)
Looking good!
Amen to that. Bet you'll have smoking before the leaves drop.:beerchug:

jaynjeep 08-28-2016 01:19 AM
Very Nice!! Great progress!!
You will have smoke rolling soon!!:beerchug::beerchug:

DieselDoctor 09-10-2016 04:38 PM
2 Attachment(s)
Here's a quick update. The D600 is set back into the frame and the hydraulics are done. The wiring harness has had the bad wires for the PTO circuit repaired and a continuity check on each wire. Before I tore the beast down, I took a few reference pictures of the harness routing. I would recommend this to everyone doing a complex harness like that in the diesel Cubs. It's a great tool to look back at. I'll take some better pics tomorrow and add to the post.

J-Mech 09-10-2016 05:20 PM
Quote:
Originally Posted by DieselDoctor (Post 391491)
I would recommend this to everyone doing a complex harness like that in the diesel Cubs.
Complex.... That's funny. :biggrin2:

Nice job!:ThumbsUp:

Sam Mac 09-10-2016 06:04 PM
This one will be good as old and better than new when your done. Congrats on a job well done. Just waiting for results of the smoke test. :beerchug:

DieselDoctor 09-10-2016 06:35 PM
Kinda busy around the back of the dash, but not really too complex for the routing if you know what goes where. This is my first Cub, so it's all a learning curve.

John147 09-10-2016 06:59 PM
That thing is looking sweet i wish i had the time and patience to paint mine :beer2:


All times are GMT -4. The time now is 01:12 PM.
Page 6 of 12 12345 6 789101112
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.