Great pic of your cub and cart!

I got the 100 back up and running. Had it torn down to replace the clutch teaser spring and made a new driveshaft. I found that the pulleys on my hydraulic pump system were worn in the V. I originally made the pulleys from aluminum but now they are steel so they should not wear out again.

I also had to weld up my muffler where the inlet goes in. It was cracked almost all the way around. The heat shield/muffler mount was cracked around the bolt holes too. I cut off my stack and made it into a short deflector to keep from cracking the muffler again.

After the 100 was fixed, I hooked up my trailer and cleaned up the limbs from the yard after the heavy wind we had last week. I hauled the mower deck to the shed and threw the snow blade on to get ready for the snow to start flying.

Sounds good, Adam! Let's see a pic of your 100 with the blade on. :beerchug:

Got the 1450 and my yard cart out Sunday to pick up some things before it starts to snow.

[IMG]http://i1094.photobucket.com/albums/...ps1251a60c.jpg[/IMG]

You need a bigger yard cart LOL. :beerchug:

Cool pic! The 1450 got the job done for ya.

I'm always amazed by what this little Cub will pull. I've had a good amount of weight on that trailer before and it never has trouble pulling. It's only when you try stopping or going down hill and turning a sharp corner I seem to have to watch it. I think the old cub may get a brake controller installed. I would feel better then.

Did some lawn sweeping with the 782. We had a lot of leaves today! :beerchug:

http://i487.photobucket.com/albums/r...ps9204077c.jpg

http://i487.photobucket.com/albums/r...ps0289a927.jpg

We had a lot of leaves today!

Looks like a bit of an understatement, bet that kept you busy for a while.:beerchug:

Looking good Allen!
That is a lot of leaves!