Cat 0 for 122 or Narrow Frame?
 

Does any one know for 100% if there is a Cat 0 hitch made for a 122 or narrow frame tractor and it will definately fit?

All of the NF lifts will fit your 122. It's not a true cat0 hitch. Check this out from the tech section of the site.

http://www.onlycubcadets.net/forum/showthread.php?t=4

Xtreme Motorworks make a Cat 0 for the narrow frames but I'm not sure which models it will fit.

From their web site:
Will not work on tractors with PTO. Designed to be similar to the 82 series kits below. Will fit the following tractors without PTO:

107, 127, 147

May fit other narrow frames with some small modifications to the lift shaft.

May fit others, but not tested yet.

http://www.xtrememotorworks.com/Part...rts%20List.htm

Yeah I seen that one from xtreme, but $500 is a lot to be a test dummy........

Could some one give me some dimensions? Width across from bottom lift arms, and the height from bottom lift pins to top link?

these are the dimensions im looking for. i need to get a hitch for my tractor and since im going to spend $125 to $150 for a sleeve hitch setup i figured i would make or buy a cat 0 3 point set up and be able to use both ways......

if i can get dimensions ill buy the lower lift arms and make the rest, should be pretty straight forward. im hoping to tuck a small cylinder under the tractor to use for lift and down pressure......

http://i73.photobucket.com/albums/i2...adet/cat0b.jpg

You'd be better off getting the IH-style 3-point and sleeve hitch adapter and using sleeve hitch implements. They are cheaper and more properly sized for a 122's size and horsepower.