New Member with Question on 1440
 

Hi guys!

I just purchased a 1440 (3rd owner) with 800hrs. and a 42" mower deck in good condition last week. Compared to my Husky, this is a monster of a machine and after researching all the brands it came down to CC and then finally a cyclops (reading/following this site over 3 months). I'm working on the rust and electrical connections, then a complete tune-up) I'll post a pic when complete.

My question...the only issue is the belt from the PTO to the deck wobbles 5-6 inches from the front of the tractor to the main pulley. Is that normal and if not, how do I fix? Finally, when I shut off the PTO (when connected to the deck), it squeals for 5-7 seconds. Is that normal and if not, how do I fix?

Much thanks and I've already learned so much from you guys!

ccguy in Western MA (but born in KS!)
1994/1440

Check all the pulleys, spindles, and the belts to see if you have a bent pulley or a bearing going bad. You may need to take a look at the air gap on the PTO it acts as a brake when you shut the deck off also idle it down before you turn the deck off. If you have some pics of the mule drive and the deck it may show something that you missed. 1440 is a cool tractor, enjoy. :beerchug:

:Welcome2:

Thanks Sam Mac for your assistance! Hi Cubcrazy!

ccguy from Western MA (but born in KS!)
1994/1440

Welcome
 

I also have a 1440, my first Cub. Enjoying it immensely. Hope you get yours going well and have a great time with it. Pretty darn good little tractor.