2011 RZT 50 torsion spring
 

I have a 2011 RZT 50. The deck lever jumping out of selected height. I need to replace the torsion spring. Anyone have pics or directions how to do this and a pic of new one so I can order one?

Thanks Jason

I have the same problem. I have my ZT ripped apart and can't figure out how this spring gets attached???? I just need a picture of one installed. Can anyone please help us?

Just found this:

http://www.justanswer.com/small-engi...-lowering.html

Thanks Flyeclair, its a lot of work to replace a 4 buck spring! So I cheated. I cut a steel piece I had down to 9 inches long and a hair over a inch wide. Ive primered it and have my second coat of cub yellow paint on it. I plan to use some industrial grade Velcro and attach the ends along side the adjustment bar and handle. This will keep it locked into place and if I want to change height just simply take off ,adjust , put bar back over it. I will post photos after the paint drys. 5 min solution to avoid a couple hours a work..

Well here's the photos...easier than pulling apart. I should trademark this before the Deere gets any ideas...lol

Let us know how that works..... I'm betting the velcro doesn't hold.

Lazy peple..... just fix it right. Couple hours worth of work... but whooping deal.