Qa-42a
 

I picked up this QA42A for $100.00 bucks. I wanted one and haven't found one here in NJ and I was going right past where I picked it up in NY. So before I begin to hunt part numbers and such I figured I would ask the pro's here. In the pictures you can see that the auger is way far in one direction. I don't think that is normal but not sure?? Any ideas on part numbers for the auger bearings?? I've seen old numbers NLA and guys paying $6.00 on eBay but had no luck looking at these old numbers and eBay didn't look too promising. I'm sure I can get what I need somewhere but was hoping maybe someone knew of a bearing number that would work. Something with a grease fitting would be a better setup. Thanks in advance!!

That is a great price. Summer is a great time to get winter accessories; they are often less than in winter.

That is in nice shape,good find.

Congrats on your snowblower!

Congrats on the snowblower!:beerchug:

A-F352 3 bolt flange $1.22 need two - A-F3Z52 3 bolt flange with Zerk $2.48 need two - A-NPS100RPC 1 in. Bearing need two $4.20. Wholesale prices from A-I products (farm supply) in Ia. not sure retail.

@Restore 49 Thanks a million, Now that my friends is a testimonial of why this is a site of experts and truly fine people!!

Thank you - passing information along makes sense. Should replace the Two needle bearings in the chain drive shaft. B1212OH - Full Compliment (more needles)the OH stands for oil hole - make sure this lines up with your Zerk fitting when installing. Bob

dieselsmoke,
Nice looking snowthrower!
Thats a good price on the bearings and holders recommended. I think I paid a lot more for the ones I got from KAMAN Bearings.
Looking forward to your restorations progress.
I believe I replaced the needle bearings also.
Regards,
Chris

Are these bearings the same for all of the Cub Cadet IH throwers as well as the BB36?

Does anyone have a good outlet for the "U" Joints?