picked up a new toy yesterday
 

Well decided to trade off the ccc 782 that I picked up for this. Came with all the belts and mounts it needed it was a simple bolt up. Now all I have to do is get my creeper installed and I'm good to go. Only problem is at some point somebody changed the shaft in this thing and didn't have the creeper roll pin hole so if anybody has the length and everything that would help me . I tried it out as best I could with just clutching it but didn't want to fry the clutch. Works great. My old lady didn't like it when I said I gotta get another tractor to use to mow now. Dang what a shame I gotta get another lol. Hopefully a 147 or something to run with my 48 inch deck .

Nice pickup!:beerchug:

The hole for the coupling when using a creeper gear is located at 13.250" from the front end of the shaft.

Thanks sam I couldn't for the life of me get a straight answer on it. Ill be pulling the engine again sometime this week to get the shaft out and hopefully be tilling up a buddys garden for him by friday he hasn't done anything with it the past few years so this is gonna be a workout

Is that a #2 tiller?

nice pickup and trade:beer2:

Good find!

Yea its a #2. The 782 was just a project roller that I wasn't sure what I was gonna do with. No engine or grille insert. This tiller is night almost can't hear it turning.