Only Cub Cadets - New Clutch Arm for 122

Page 1 of 2

Show 40 post(s) from this thread on one page

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)

- IH Cub Cadet Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=9)

- - New Clutch Arm for 122 (https://www.onlycubcadets.net/forum/showthread.php?t=29185)

Calvins66Cub

12-29-2013 08:24 PM

New Clutch Arm for 122

3 Attachment(s)

I made a new clutch arm for my 122. Before and after pictures. Replaceable pins that contact the bearing. Heim joint to foot lever. Has anyone used aluminum clutch pressure plates(not the clutch disc)?

Jeff in Pa

12-29-2013 08:44 PM

Beautiful work :beerchug:

As a machinist and fabricator for over 35 years, that looks very nice. Well done.

jcsmith

12-29-2013 09:00 PM

That is sweet. Zach Kerber offers aluminum pressure plates, but I know you can whip up a sweeeet set. Nice work. Chris

IHinIN

12-29-2013 09:08 PM

Nice! Too bad it will barely be visible once it's on the tractor.

I'm not sure how aluminum pressure plates would hold up. They may wear quickly and the spiral pin slot may get wallowed out in the rear plate.

Calvins66Cub

12-29-2013 09:21 PM

Quote:

Originally Posted by IHinIN (Post 234259)

I was thinking the same thing. Might just go with steel anyways. I looked at Zach's pressure plates, they are steel. Thanks for the input!

ACecil

12-29-2013 10:00 PM

Great job!

Cubcrazy

12-30-2013 07:22 AM

Nice looking piece!:beer2:

Sam Mac

12-30-2013 07:38 AM

That is a work of art! :beerchug:

DoubleO7

12-30-2013 07:44 AM

Quote:

Originally Posted by Sam Mac (Post 234317)

That is a work of art! :beerchug:

And a beauty too.
Gonna anodize it too?

(As long as it ain't green)

Yosemite Sam

12-31-2013 05:23 PM

Wow! Very nice.

All times are GMT -4. The time now is 03:16 PM.

Page 1 of 2

Show 40 post(s) from this thread on one page