Only Cub Cadets - A couple of cuts on my 1942 Monarch lathe

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)

- General Talk (https://www.onlycubcadets.net/forum/forumdisplay.php?f=24)

- - A couple of cuts on my 1942 Monarch lathe (https://www.onlycubcadets.net/forum/showthread.php?t=37321)

Jeff in Pa

02-21-2015 02:39 PM

A couple of cuts on my 1942 Monarch lathe

I took a short video of my 1942 Monarch CK 12 lathe making a couple of cuts at a 1/4" deep in steel.

https://www.youtube.com/watch?v=t8C6_ANZoGQ

Sam Mac

02-21-2015 03:54 PM

Nice! :beerchug:

Terry C

02-21-2015 05:00 PM

What kind of inserts do you use? .008-.010 per ?

Jeff in Pa

02-21-2015 05:08 PM

Quote:

Originally Posted by Terry C (Post 312918)

What kind of inserts do you use? .008-.010 per ?

CNMG432 @ .012 per rev The rpm was 408

Terry C

02-21-2015 05:55 PM

I use wnmg on turning just cause of six sides. Iscar PP chip breakers.
That old girl of yours sounds good.

Terry

Calvins66Cub

02-21-2015 06:00 PM

Nice job Jeff! You should check out Abom79 on Youtube he has a Monarch lathe.

darkminion_17

02-21-2015 07:44 PM

very cool Jeff,Watcha making?

Billy-O

02-21-2015 07:54 PM

Quote:

Originally Posted by darkminion_17 (Post 312980)

very cool Jeff,Watcha making?

spiral shavings

Jeff in Pa

02-21-2015 08:26 PM

Quote:

Originally Posted by darkminion_17 (Post 312980)

very cool Jeff,Watcha making?

http://img.photobucket.com/albums/v7...c.jpg~original

Quote:

Originally Posted by Billy-O (Post 312989)

spiral shavings

Ever notice the blue chips fresh off the machine are "too heavy" to hold? :biggrin2:

Jeff in Pa

02-21-2015 08:26 PM

Quote:

Originally Posted by Calvins66Cub (Post 312943)

Nice job Jeff! You should check out Abom79 on Youtube he has a Monarch lathe.

:beerchug: Nice set up "in his garage".

All times are GMT -4. The time now is 12:51 PM.