Simplicity wiring help
 

Hey guys,
I'm trying to hook up all the wires the PO disconnected.:bash2:
I can't seem to figure it out, I have an F post, an L post and a BAT post, and a post underneath the voltage regulator, I did run a wire from the BAT post on the voltage regulator to the pos on the battery, any ideas?

It wires up the same as a NF Cub Cadet. Use one of those diagrams.

http://www.simpletractors.com/servic...al_systems.htm Look here.

Thanks, I tried following the wiring on a cub but I got it cranking even though some wires aren't hooked up and it backfires and the crank shaft kicks back the opposite direction.

That's an engine problem, not a wiring one.

:popcorn:

O.C.C or is it O.S T.?

He posted in the General Talk area so he's is just fine here. It's a Kohler so I don't have a problem with the question he is asking and I doubt that any of the other Mods have a problem.

Sam,
It is a briggs,non cub,Can I post about my variator troubles on my JD 110 ,it has a kohler in it?

OK with me. That's why we have a general talk area. I've posted my JD dump truck in this area.

Ok guys settle down.:biggrin2: