127 lift bar dimensions for 3 point
 

Hello I am fabricating half of the parts I need to install the 3 point lift on my 127 and I need the specs on the lift bar
thanks

Does this help?

http://www.onlycubcadets.net/forum/s...50&postcount=1

Yes it helps but specifically I'm looking for the center to center measurements of the rod that actuate that

You do realize they are only $35 new right? You also need the plate that the bar connects to too.

Go about 3/4 of the way down on the page.

3 point parts

If you still want to make one, the bar stock is 7/16" thick x 1-3/8" wide x 25-9/16" long. The holes are 24-1/4" apart on center. One hole is 49/64" id. and the other is 41/64" id. The bushing that goes on the bolt and in the large hole is 33/64" id. x 3/4" od. x 1/2" long.

Actually the lift bar is only $22 here at one of the site sponsors. It's the 4th item down.

Lift bar

Here is a drawing of the lift bar. I always make them because I have the metal.