Could these work
 

While searching around, I found this online.
I got 2 seals that fit the Danco UD-6 creeper that fit at my local bearing house(he had to order them)
SKF 13662 and they were $6.02
The expensive seals I got CNH 938294R91 are not Creeper seal and use on some other IH equipment. They fit bt may present a problem with not enough room and putting strees on the mounting brackets.
I think I will order 2 and try them? They look like they will work. What do you guys think?
http://i458.photobucket.com/albums/q...pscn6b8jc6.jpg

Here's the other one. It's upside down.

http://i458.photobucket.com/albums/q...psnnf7zi07.jpg

I don't understand the question Ronnie?

The old seals should have a number on them. (Even if they don't they can be crossed by size.) Any bearing/seal store can cross it. I'm assuming that the seal in question didn't fit was too thick and caused mounting issues? If so, then get a thinner seal. Seals and bearings are easy to find.... If you need a phone number to a good bearing and seal place, and don't mind to pay the shipping, I can get you at least 2, maybe 3 phone numbers.

I know that CC specialties has them. What I am asking is would these 6.00 seals work? The part number is there, SKT 13662. On that forum, someone tried them and it worked, hence, the copy of the thread. I guess I am just bored because I can't do anything but look at this computer!!!!!

The number on the seal is VG 64454 crosses over to SKF 13649 Pull out your old one and see if it measures the same.

http://www2.chicago-rawhide.com/popu...kup_457012.htm

And there it is. Lew has the info you needed!! :beerchug:

Oh lew! your my hero.!!

:biggrin2:

Attachment 78763


Bill

Thanks for that link Lew. That will help me a bunch.

(Does your creeper leak?)
I don't know? I just thought they should be replaced before installation?:bigthink: