How a rear sleeve hitch works with hydraulic lift?
 

Could someone be so kind to explain how adding a sleeve hitch works on my 1650. It has hydraulic mower lift so does sleeve hitch hook to that some how? Thanks and pics would be really helpful😁 not really understanding the whole sleeve hitch set up. Thanks

First, welcome to OCC..... :Welcome2:

Click on this link...... Sleeve Hitch

Specifically, here is a Wide Frame Lift Assembly.

Sleeve hitch works off the same lift cylinder as the mower deck. So does the front lift for a blade or snowthrower. They all use the same system. So, you can only have one implement on the tractor at once. They all 3 lift and lower at the same time. Pretty simple set up.:beerchug:

#3 bar?
 

So the #3 bar in the pic goes to lift cylinder?

#3 part fits to rocker shaft

Hitch
 

Yes but the other end must go hydraulic cylinder?

Pull your tunnel cover off and you will see where it hooks to. # 3 runs inside the right hand side of the frame.
A piece of solid rod goes in the rearward facing hole in #2. That’s what does the lifting is the rod in number 2

odel33 answered correctly. If it makes more sense to say it attaches to a cylinder, then sure. In a round about way it is.

Go to this link.... WF 3 Point Installation

Right hand side, at the bottom "WF 3PT Install"

Here is a copy of the instructions.
https://drive.google.com/open?id=17r...iZLluVz5qm-F_w