1200 chutch replacement
 

Any good ways to replace drive chutch and costs ?

Parts available and prices listed with sponsors above. Good way to replace is have someone else do it. If you cant do that then just try to not bust your knuckles up too badly.

While this isn't going to be helpful, I've done this a handful of times over the years the first time as a"kid" before the internet and the Youtube,:bigthink:. Its not the worst job out there at all.

yup. done it a few times myself. if you need couplers or a new shaft (more likely than not you will) check with Parts by Jeff on those, he makes them and they are better than what was issued with these machines from new.

Giddy, go to the Technical Library-Tractors, first page. There's a great tutorial by member 'Merk'.

It's an easy job.:beerchug:

I put a clutch in my 1000 back in 2016. This was the first clutch since it was sold new in 1977.

I highly recommend a new driveshaft from Jeff in PA. I sent him the original shaft from my tractor and he made an equivelent replacement. The original shaft had steps worn in it that would have made it impossible for the pressure plate to move.

I have a couple of threads that discuss my clutch replacement:

https://www.onlycubcadets.net/forum/...ad.php?t=39129

https://www.onlycubcadets.net/forum/...ad.php?t=43135

If you have any questions post on this board. I learned a lot here.

Bob