New Member - XT2 LX54 FAB
 

Currently have an XT2 LX54 Enduro Fab that is not engaging the blades. I have used the meter to check the PTO clutch, PTO switch, module, seat, etc... All have power going to it until now. Ordered a new module that is not showing that it's receiving power. The module before replaced by me did have a few error codes but unreadable.

Previous work (by another shop) bypassed the module (as they said it was inoperable). It's plug and play so everything should work but the new module has no power.

I've spoken with Cub Cadet and have the wiring schematics but my other question to (besides any help) is org/white go to org/white and red/red ?? The machine keeps blowing the fuse. I'm at a loss (except that the previous work has the wires in the wrong spots?)