Quote:
Originally Posted by donnelly.me
So lean sounds really bad but what should my plug look like? I know it shouldn't be white but I really don't know and I'm a worrier! Is gray okay or does it need to be darker? Also, I wiggled the throttle shaft and it did change the way it ran slightly. Do I need a new carb or is there a sleeve or something that I can install. Now while I'm at it, I have yet another question. Unless the engine is warm I usually need a small spray of starter fluid to get it going but then always runs fine once started no matter where I set the idle. Is this also to do with my carb setting?? Thanks again.
Mark  |
As for the carb throttle shaft, here is the my link on what you need:
http://www.onlycubcadets.net/forum/s...ad.php?t=10329
You shouldn't have to use starting fluid. You may need to check the timing and maybe a new set of points and a condenser.
Timing link: http://www.onlycubcadets.net/forum/s...ead.php?t=4405
__________________
DWayne
1973: 128, ag tires, 3pt. lift, spring assist, lights, 42" Deck
10" moldboard plow
2016 XT1 42" deck 18HP
|