well pulled the back plate off and inspected the relief ball/spring the sleeve was a little rusted so i replaced it with one i had laying around that was good and I noticed the spring from another engine had smaller coils(like thinner) on the spring and the spring out of my engine was a little stiffer(thicker coils) so I am taking a gamble and changed it out we will see what happens when i get the new seal I must have nicked the new one when i put it in cause there was a small cut in it and that is were it was leaking so lets see if i can do this again but i am going to run the motor off a belt off my sears and see what the oil pressure is before i put it back in the tractor and start it
|