Quote:
Originally Posted by mmzullo
So it's the shorter 1.
I'll measure it for you tomorrow if I get a chance.
Mike
|
Thanks
Quote:
Originally Posted by Jeff in Pa
That's the pin I have in the lift on the 125.
The shorter one is about 7-1/2" long, the 1/2" hole is 7/8" in from the end and the hole to secure it to the casting is 3-1/2" from the end.
|
Long one is 9-3/4" long, first hole is 3/4" from the end and the second hole is 2-1/4" from the end. The distance to the washer is 4-3/4". The cotter pin hole is 1/2" from the 1/2" hole side of the washer and the other cotter pin hole is 3/16" from the other end.
It looks like the inner hole on the long pin and the short pin have the same distance.