[inspectorudy]

As I mentioned above I found a supply house for all of the lines, hoses and Jic fittings that I will need but then when I go home I ran into another problem. I bought a PS valve bracket from Extreme Motorworks and it doesn't fit my tractor. I can make it work but the bottom of the valve hangs down too low. I cannot find how far below the frame rail the valve should be and was wondering if any of you could take a measurement and let me know. I'm afraid if I go with the bracket the way it is now it will interfere with the mule or mower hanger. Once I get the measurement I can cut the bracket I have so that it will hold the valve at the proper height and then I can cut my lines and hoses to fit that height. Here is a picture of the bracket I have now. I actually need the "Y" shaped type that only fits over two of the studs. I'll be glad to trade with anyone who needs this brand new one for your old rusty one! Here is the one I need that is NLA. I can make one if I knew the demensions. If anyone has one that you can get to I would appreciate the measurements of it.