I'm wanting to make this to make hills and rows for seeds and hilling with a trench for seeds. Please forgive my rough drawing, my goal was to make a pic that wil show how it would look once built. The pics show what I've got to work with. I saved these from the scrap yard a while back. It will be adjustable with the brackets in the pics. I'll be able to raise or lower or remove each section by adding or removing parts as needed for the task at hand.
Parts I have on hand to use. The parts on the right would allow me to choose the width of the planting furrow.
Attachment 22185
Bracket side view.
Attachment 22186
Bracket top view.
Attachment 22187
How I have it set up to make a hill with a planting furrow at the same time. Without the two sides attached I could make a planting furrow.
Attachment 22190
How the cat0 would look. Rough drawing please over look it just trying to get you to see what it would look like once built. Not to scale!
Attachment 22191