Quote:
Originally Posted by ol'George
ya might want to "pin" that Gov.puppy!
I run the oil filter in the origional position on the side of the block.
I just made a nice clearance hole in the air deflector, no problems.
either way works good.
Make sure the in and out lines are in the correct location.
|
Thanks for the service buletin on pinning the govener shaft.
As far as the in and out of the oil lines, I'm believe the center hole is the pressure or feed port. The vacant area below that is the return? I plan the plumb the "feed" or pressure hole, to the center of the filter head adapter. This would drive the oil from the center of the filter, outward.
I think thats right?