I just went this route with a 1A tiller on my 1450. Get the correct, straight mule drive. I tried using a 50" deck mule. Without a shop, it's almost impossible to "straighten" the angled arms. I'm using a mule for a 42 inch deck, but will get a mule for a 44 inch deck. I'd rather have the arm on the left that tells you the belt is tight by just looking at it, rather than having to get a tape measure to check it. Might be an old age thing, sometimes I get down and have a hard time getting back up!
IH-61959-C1 7/16 X 145-1/2 BELT, is the belt I was told to purchase for the 1450.
__________________
Papaw
1984 CCC 582 w/ creeper, 42" blade, 44C deck, 220# wheel weights, 2 link chains & adjusters, Spring assist lift.
|