Quote:
Originally Posted by mrcubcadet
This is what I have:
The end of a 1650 drive shaft fits right in the bushing on this 3 pin clutch plate from a 124 (starter/generator type motor)...
|
Due to the motion of the engine allowed by the ISO mounts, the driver for a Quietline tractor specifies a ball swivel bushing to make up for the motion.
I am thinking about welding in the ISO brackets on a 1200 I am building to eliminate the need for the ball swivel bushing.
I just assembled my first Quietline ISO framework last week. That one may get welded before it is over.
I can not see a reason for not welding in the ISO frame!!
I spent 15 minutes getting the oil pan to set correctly at all 4 corners.
I came back and checked it again 30 minutes later and the bushings had settled some, there is a lot of movement associated with the ISO mounts.