[Methos]

Originally Posted by darkminion_17

Remove spark plug wire.
Then set the brake pedal.
Then remove the 2 roll pins on the clutch shaft holding the plates on first,then the engine mounting bolts.
Then the 3 pin driver bolts.
Loosen the turnbuckle on the pto arm and remove.
Then loosen,but don't remove the two back bolts on the grill housing.It tips it back for more room when sliding the motor back.
Slide motor back and turn it to the right side slightly.
Then remove the driver,pressure plate,disc,pressure plate and teaser spring.

Be sure to put the bolts back in the driver before reassembly of the clutch plates and disc.

Time,4 adult beverages.

Would 4 pepsi work?

Lew thanks for the info going to try that next time I work on a clutch.