Quote:
Originally Posted by cleon001
Thanks for the reply cavmedic and DX3. I see how the engine has the 4 bolts on the bottom of the oil pan that mount the engine to the cradle and the ISO Mounts that mount the cradle to the frame but I still have not found out how to disconnect the drive shaft from the engine. I see the 4 bolts that go through the flexible rubber disk and I have removed the nuts on those bolts. But the bolts cannot come out as they are too close to the engine to remove. Checking the manual DX3 provided page 1-7 states "Disconnect the drive shaft front felxible couple from the engine" but does not give any details on how to do that. The picture that accompanies it points to two of the four bolts with a caption that says "Discconect here". Yet the picture at the top of page 1-7 shows absoltuly no trace of the drive shaft. How does one disconnect the engine from the drive shaft? Does this happen if I slide the engine forward as I remove it after unbolting it from the 4 bolts in the oil pan? How is this suppose to be done? Any advise and guidance is appreciated.
Thanks
Cleon
|
Yep, you are right, just 2 bolts and slide the engine forward.
You got one of these??
I hope you add one of these!!
