Quote:
Originally Posted by truckntran
I was looking at a 1450 the other day where the axle had broken in half at the pivot.. seemed it was dropped off a truck.
If you check out one of the pulling sites they talk about spindle reenforcement...I don't remember where I found it but it may have been on Brian Millers site.
http://**********************************/steering.htm
Spindles are on Ebay all the time.. I need a left for a 100 series myself.. |
PF Engineering has a good "how-to" on converting to a 1" greasable hub for the fronts on wide-frame spindles. I plan to give it a try this spring on my 1650, since I eventually plan on building a loader for it. I think the cub faq page also has a similar how-to.