[ccannon222]

I recently picked up a 1250 that was half taken a part. I am in the process of putting it back together and I am having a bit of trouble with the Electric PTO. I have never worked on one before (First wide frame in my fleet). When I tighten the adjusting nuts and measure the gap I cannot get it down to .01”. It is at .03". If I continue to tighten the adjusting nuts, the plate comes in contact with the disk that is connected to the pulley. I will try to get some pictures next time I’m over at the shop. I have the service manual and I believe I have followed everything correctly. Maybe I do not have the bolt on the end of crank tight enough. How many ft lbs does this bolt take?
Thanks

Chris