Quote:
Originally Posted by CADplans
It must not be real hard to do, I welded one up one Saturday!!?? 
Why not give it a try!!  |
CADplans,
I agree, but what I need are the dimensions especially for the lift bar and attaching hardware as shown in the picture I posted earlier (part # 3 & 4). Is the bar straight or does it have a bend in it on its way to the forward connection point.
I can guess at the rear cast portion dimensions and assume that the lower lift bar is 90 degrees from the implement attaching point. Should I assume that it is in fact 90 degrees? What is the distance between the center of the thru shaft and the center of the lift bar connection point?