2084 Questions
Recently I over greased the front axle and got some grease flying everywhere. I also today changed the breather filter and gasket. It was running well when I shut it off to change the breather and gasket. To accomplish this only one electrical connection was dealt with. I removed the wire from the oil sensor and today replaced it as part of the reassemble. Once we got it back together it seemed as dead as a door nail. Checked the fuse and it was blown. Replaced the fuse and it too blew. The original fuse was a 20 amp fuse. We did put a 25 amp fuse in and it started and ran only a few seconds and again the fuse blew. I know next to nothing about the electrical system so any help and or hint where to start looking would be most helpful. Would grease cause a short as the flywheel area had a bit in there and the modules are located there too.
__________________
With my son, EricR Super 2084 with 54" mower, 451 blower. 2086 with 3 pt hitch, 54 inch deck, 551 blower, 54 in brinly blade. A 4 digit original w deck. A 70 with deck. 2 102s both with 42 in decks, one with creeper, 1 36 inch IH snow thrower CW36, 1 42 inch IH blade. 149 with mower. 2072 w 3 pt hitch, Johnny bucket, 60 in mower, 451 blower. Jacobson GT 10 with mower. DR Lawn vac tow behind,Home made lawn roller. Brinly cart, 2 off brand carts and 1 home made cart.
|