I built a Cadplans loader and know what the big problems will be to adapt a ready made FEL to a CC. I used a Simplicity for my mount and it worked great but it was NOT a quick disconnect FEL. If you buy this loader and look at the under side mount where all the problems will be and then decide to sell it and do as someone else said and use the money to build one for you own tractor. But know this, it will be a dedicated FEL tractor. There are some tractors out there that have "Drive On" FEL's but it is hard to build one that is truly drive on. If you have an extra CC then go for it but do not expect it to be a mower one day and then a FEL tractor the next. It is too much to expect from simple machines that do a good job for what they are designed to do. If our tractors had a hydraulic system that would support a FEL then it would simplify the job but with our system you have to add a hydro pump, reservoir, rear weights and the belt drive to run it. It works great but it is not a quick change that truly is a multi-tool that we all dream about. No matter what you decide the fun in all of this is to just do it! You will either end up with a FEL on your CC or you will end up with some extra cash. Either way you will be happy!
