m18
Hello, I put one in my 582. The crank was 1x 3/916. Would you beleive the 1" pto off the briggs slid right on and bolted up? The holes were in the block and threaded but not used. I needed a 3/4" spacer to fill in the extra cranhshaft under the bolt. The motor was out of an Ayp that used a pto spaced away from the block held in place by a bracket. If you need to use a 1/18 pto Sam Mac has a way to bush that up and work. Mike, ps Hi Vince, going to an auction to watch a 1/2 scale baker steam engine sell today, maybe, it has a reserve.
|