[inspectorudy]

I only have the one fuse on my front panel so I can't help you with that but the brakes are real simple. With the brakes off look under the left foot board and you will see the linkage to the rear brakes. It should be loose but not hanging down. Now tighten the nut on the linkage so that the linkage is just barely tight but not actually taking up tension on the rear brakes. Then set the brake pedal and re-check the brake linkage and also see if you can move the tractor. If you can move the tractor then you need to tighten the linkage a little more until you cannot move the tractor. Then release the brakes and check the linkage again to see if it is taught but not tight. That's all I had to do but then I didn't have any issues with the brake pads or rear calipers. You can also see if the two brakes are about equal when pressure is applied to the pedal. There is an adjustment for side to side. Good luck.