I need a larger V-groove for a 5/8 belt rather than the 1/2 belt that my #1 is made for. A trade would be great if the shaft sizes is the same except mine now has a very small chip on one edge of the V-groove, which I might be able to braze back in the piece that broke. Sounds like a #2 tiller might use the belt I need. If you get your pulley off, lets talk. Mine is off. Also I found it hard to pull mine off so I took the cover off the gear box and removed the C-clips holding the gears and then pushed the shaft out the bottom, then used a press.
|