So I drained (most of--as you can see some is on the floor, but some of that was from the leak) the oil again, got her jacked up, and I got the c clamp off and the axle out and I don't have a puller tool that the service manual describes, so I've been kind of ruining whatever that seal is--I think it's the one I'm replacing? The rubber on it was partly gone, but before I completely destroy something I don't know exactly what it is getting it out (I'm using a couple flat heads, any suggestions are welcome) I figured I'd double check I have the right part before I have to go the store again.
I have red arrows pointing to the gasket I'm talking about (the outermost one)--It looks like the part I have, and feels like it too from the inside, but it's got so much grime on it I just want to hear from someone else who's done this before I make more work for myself
|