Thanks Merk, thats exactly what I needed. I figured the po modfied it to fit the wide frame. It actually had a couple 2" pieces of flat stock welded towards the top of where it mounts to the rod. He actually bent it apart to fit between the frame and the foot beds . Outside the frame. Worked on the 1250 because the hydr lift did not interfere. Must have been easier for him to line up with out getting down and looking under the tractor, who knows. But now that I am mounting it on the 1200, I cut the braces off and pulled it together with a ratchet strap and rewelded a brace to hold it there. I have it mounted as shown in your pic . Had to bend the rail a bit to clear the lift bracket . This frame is pretty tweaked from the po bending it for what ever reason. I had to cut the front locking pin brackets off , mount the plow and reweld the pin hangers in so it would all fit. Hopefully all will work as we have a major snowstorm coming. Both are ready , the 1250 with the blower and the 1200 with the plow right behind her.
|