Some work continued today on the 782 deck The front roller holder was pretty egg shaped so I had an idea
Welded a washer on the outside and filled in the inside gap with weld and filled it round again. Next I built a new pin because you can clearly see it was in need of some attention also.
Took some round stock I had around and cut it to length, then welded two washers on the one end. Just need to drill a hole on the end yet and good to go.
Needless to say, it's good and tight now. Still need to straiten the front of the deck where it's pushed in. Then sand blast and new paint.
Also have a question regarding the deck. My tag reads, MODEL# 44" Deck 35819x 44C
Ok, when I looked this up on Part Tree for the 782 tractor, the picture shows the deck should have wheels at all four corners. Mine just has them on the rear corners. ?
Thanks