View Single Post
  #1  
Old 03-10-2013, 08:37 PM
smithth11 smithth11 is offline
New Member
 
Join Date: Mar 2013
Location: NJ
Posts: 5
Default 1250 trans release lever

Just got a 1250, and if anyone could provide a diagram or description of what the "release-drive" lever on the right side below the seat on this older model connects to I would appreciate it. I haven't been able to make it out on any on-line dragrams found so far, and with the rear covers off still can't figure out what's missing. That small lever shaft under the frame top cover is not connected to anything and the Cub stars & runs fine but the trans will not engage in either direction. Filled to the top of the rear differential plug with the HY trans fluid, it took the better part of 1 gallon, but still no movement. I can push this Cub so I assume either the trans is disengaged or it was already ruined. I'll be optimistic and change the filter just in case it's that simple. Thanks for any help on this.
Reply With Quote