Wind sock at the airport, now that made me chuckle .:biggrin2.gif: McMaster Carr sells some bronze oil impregnated bushings with a 3/4" id and an 1-1/4" od 1/16"thick. They work perfect for shimming the shaft float. I have 1 on the pto side because the sprocket had a circle worn in it from the needle bearing race. But I put 3 on the outside . When I started using it the sprocket would pull to the outside under load so I added more to that side. But I tightened the tensioner equally on the bolts lenght wise. Mabe I should give the outside a little more than the inside to over come the pull as the sprockets are closer to that side. Made me think olgeorge , thanks.
|