Thread: testing Ignition coil command CH22s
View Single Post
  #1  
Old 04-22-2013, 08:47 AM
timbo2's Avatar
timbo2 timbo2 is offline
Senior Member
  
Join Date: Apr 2011
Location: Kansas
Posts: 393
Default testing Ignition coil command CH22s
Hello -

I did some basic testing on my 2284 which has never run right/starts hard.

I'm focusing on the Ignition modules at this point and tested the resistance on the spark plug lead to ground:

left side - 10k ohms - in spec
right side - 191k ohms - way high if I did it right

The manual spec says 8k-40k ohms range for that coil.

before I remove shroud and test the other tabs on the coils I wanted to make sure all the resistance readings should be done with black lead on meter going to ground.

Thanks,
__________________
- Tim
1872 60" Haban deck- 2082 450 blower, 50c deck - 1450,1650 2x44a deck, QA-42A snowthrower, 70 w/k181(destroyed) 38" pin on deck
Reply With Quote