Quote:
Originally Posted by J-Mech
I'm not sure where to put this thread, so, if you need to move it please do.
Does anyone know, or have seen this before? I ran across this and did not know that a new replacement was available. Has anyone seen the top trans shaft that goes with it offered new? I searched this guys other stuff, and looked him up, but didn't see the trans shaft. If these parts are available new, I think we can build the rear bearing holder..... Comments?
http://www.ebay.com/itm/Farmall-Cub-...71196024038%26 |
I bet they are machining news ones and are using the bearing holders again. You could make the bearing holders but it would take some doing to get it done right.
