Quote:
Originally Posted by zippy1
Can you grab the blade and wiggle it and get up and down movement?
And check to see if you have same number of washers on each, not that, that would give you a choppy cut 
When you get it figured out, you'll like the way these decks cut. http://www.onlycubcadets.net/forum/s...ad.php?t=22197
Here is a link to my 44c deck rebuild, may help. |
I gave it a good wiggle Todd. The blade does not move and is rock solid. The bearings may be fine. Perhaps the blades were not balanced when put on? All the blades have the same amount of washers.