[bbarsh]

Originally Posted by Frank1541

I had the same problem with my 1541 after I took the engine out to replace the rear seal. When I put it all back together the heat shroud was too far forward. I ended up loosening all the bolts that held the engine to the frame and the shroud to the engine and pushing them all as far back as possible then re-tightened everything. It helped, but I finally ended up cutting part of the shroud off to get the plastic back on. It is still one of the stranger things to happen with the my cyclops. It is no longer an issue since I put a Command engine in last year. The command heat shroud is not as big.

Thanks, I'll try that