Quote:
Originally Posted by J-Mech
Nothing like a lifter to bore. Or a piston to a sleeve.... No, MUCH tighter than that. They are sized to the bore at the factory. If you take one out of it's hole, hold it in your hand to warm up.... It won't go back in the hole you just took it out of. The only thing close to the tolerance of this is inside a diesel injection pump. You can put them back in... but the hydro may not last long. If your lucky, they will have enough wear on them they will be ok. But, don't be surprised if it fails.
|
Well, thats not good news. I wish they marked them. I don't see how I have much choice but to go with it. Even if the parts are available I'd bet they cost a mint, and even if it sizes up I still have to buy it. Do you have any first hand experience with these units failing due to this?
I'm going to check into this a little, and I'll let you know what I learn.
Thanks for the input.
M