drive shaft mod
I have a 1210 and I got tired of the drive shaft vibrating. I picked up a 1440 that the engine had been removed from and swapped the trans from it to the 1210. It was a bolt in swap except for the drive shaft that had to be shortened. I cut it then welded it together and put a sleeve over it then welded the sleeve to the shaft just to make sure it wouldn’t come apart. Had to put a disk between the engine adapter and the CV joint to keep the grease in. So far no problems. Also used the rear tow plate with the spring lift assist from the 1440 and the steering box after I modified it. I guess the 1210 is now a 1240?
|